I can take metal off quickly, but putting it back on would be very difficult. I haven't taken a grinder to it yet, as I'm not sure if that is wise. Regarding the anvil, I have worked the top and sides with a wire-brush to remove some of the rust and paint. For the ends you should add 1/2 inch for slop and 3 1/4 inches to overlap the two "side" 2x4s. You can make the sides about 1/2 inch longer than the length of your anvil/swage base. This is the height of your uprights (22 inches in my case). I used this trick when drilling the feet for the napkin holder featured in AW 38. If you want to make one, measure from the floor to your knuckles, add 2 inches to avoid hyper-extension of your elbow joint, and subtract the height of your anvil. For that purpose, I made the stand hold a 12 x 9.5 inch tool. Since I have limited floor space, I might end up using the swage block in the same stand. The anvil base measures 9.25 x 11 inches, and the swage block measures 12 x 7.5 x 3.5 inches. I am not sure if I want to use the same stand for both anvil and swage block, or to make another one to support my swage block. Since I used 4x4 supports, I haven't added any metal strapping or cross-bracing to this. Seeing as the anvil is my favourite work space, I wanted it to be heav. He's driving west in a brown Chevy 4X4 van. The ship shop needed a workbench, so I made a mobile anvil stand for our Lady Fisher. I also tried to keep my screws away from the edges to avoid splits. he asked in awe as O'Brien grabbed the keys from the bed stand. I used a carpenters square and wood clamps to hold the 2x4s in place as I screwed them on. I slanted each screw differently so it would be more stable, and put 2 screws into each end of the 2x4s. four 2x4 boards 12 3/8 inches for ends (these boards overlap the ends of the other 2x4s)Īll of the material was leftovers from building a deck - ACQ treated lumber and coated screws.four 2x4 boards 12 1/2 inches for sides (these boards are flush with the uprights).I modified the design to fit the miscellaneous lumber that I have available. I spotted a simple stand at the January 2006 Saltfork Craftsmen's meeting that I think I could build.
0 kommentar(er)
